Round Plastic Chair & Table Inserts
Our quality & durable round ribbed inserts provide protection for the floor from scratches and damage caused by chair and table legs. They can also improve the stability of the furniture by preventing them from sliding around, and reduce the noise caused by furniture moving.
These inserts are easy to install either by hand or tapped in using a rubber mallet and are ideal replacements for worn or missing feet to extend the life of your existing furniture.
Our inserts are manufactured in the UK, they are high quality, durable and long-lasting to withstand heavy use in a school classroom setting.
Our range of heavy duty chair inserts are also suitable for neatly closing off metal tubing.
All our round chair inserts prices include Free UK delivery. Please enquire for delivery costs to destinations outside the UK
Round Chair Inserts, Round Table Inserts
-
SP149: 1/2″ O.D. Round Chair Inserts / Round Inserts Ribbed
From: £5.00 -
SP23: 5/8″ O.D. Round Chair Inserts / Round Inserts Ribbed
From: £5.00 -
SP4: 3/4″ O.D. Round Chair Inserts / Round Inserts Ribbed
From: £5.00 -
SP2: 7/8″ O.D. Round Chair Inserts / Round Inserts Ribbed
From: £5.00 -
SP6: 1″ OD Round Chair Inserts / Round Inserts Ribbed
From: £5.00 -
SP15: 1 1/8″ O.D. Round Table Inserts / Round Inserts Ribbed
From: £5.00 -
SP21: 1 1/4″ O.D. Round Table Inserts / Round Inserts Ribbed
From: £5.00 -
SP70: 1 1/2″ O.D. Round Table Inserts / Round Inserts Ribbed
From: £7.90 -
SP71: 2″ O.D. Round Table Inserts / Round Inserts Ribbed
From: £7.90
Our trial packs are available as a set of 4 pieces so you can test them on a chair or table. Prices from £5 for a set of 4 including P&P. Try them out for a fiver!
Please note that we still offer free single samples of each fitting for you to try on your furniture to ensure a correct fit before ordering.
Listed above are the most commonly-used sizes of plastic inserts, but please enquire if you need a size that isn’t listed here because we have numerous other sizes and types of chair & table feet available, many already in stock, or if not in stock, we may be able to source them for you.
Please note that when measuring for inserts, you need to measure the Outside Diameter of the tubular leg, not the size of the hole that they fit into. This is because the plastic on the tip of the insert has to match the widest measurement of the metal to ensure that all the metal at the end of the leg is covered and thus the floor is properly protected. Please refer to our Fitting Guide or contact us if you are unsure.
If you are not sure of the size you need, or your size is not shown on this page, please contact us to ask for advice or for our Free Sample Pack.